|
|
Air
|
| Air Pressure |
80 PSI +/- 10 PSI |
| Air Purity |
<5 Micron Filtration |
| Air Temperature |
68 Degrees +/-5 |
| |
|
|
Water
|
| Spindle Cooling Water |
68-72 Degrees +-5 |
| Pressure |
35 PSI +/- 8 PSI |
| Water Purity |
50 To 100 Micron |
| Water Temperature |
72 +/- 5Degrees of Ambient |
| |
|
|
Movement andAccuracy
|
|
Y Axis
|
| Total Motion |
greater than 6" |
| Index Repeatability |
.25 um |
| Accumulative Error |
None |
| Minimum Index |
.25 um |
|
|
|
X Axis
|
| Repeatability |
1 um |
| Accumulative Error |
None |
| Return Speed Max |
12 inches/Sec. |
|
|
|
Z Axis
|
| Repeatability |
.25 um |
Theta Axis Rotation
(Manual or Auto) |
360 Degrees+ - 2 arc seconds |
|
|
|
Spindle
|
| Size |
4 inch |
| Power |
3300 watt with power boost |
| Type |
High power air bearing,water cooled, 3
phase |
|
|
| Dimensions |
36" W 32"D 24"H |
| Weight |
750 Lbs. |
| Power |
110 VAC 50/60 Hz |
| Current |
40 Amps |
| |
|
| Note: Specifications subject to change without notice. |
|
|
It has been long overdue . . . renovating a dicing saw that incorporates
current computer technology coupled with innovative software engineering
to meet and exceed your expectations, even in a new saw.
 We
start with the complete removal of all the hardware on a saw (mechanical
and electronics). The saw is stripped and repainted.
Then we add a newly designed computer, wiring, hoses, electronics,
motors, CCD camera, monitor, black or white dual line reticule generator,
our new high power LED part illuminator tuned for the CCD.
Finally a Color active flat panel touch screen interface is added.
A new saw? Almost. We could replace the frame, air slides and screws, but
then we would have to charge you over $100,000…the basic cost of a new
saw. With about 40k of investment you can have all the newest advancements
in electronics, programming and motor technology.
Programming and positioning of the (X), Index (Y), Vertical (Z),
and Rotary (Theta) axis is accomplished on the Color Touch Screen with
a user friendly color coded hierarchy tree intuitive menu.
Standard Programming options include:
1. X axis cut rate from .002 to 12 inches per second.
2. Y index variable steps from .000002 to 6 inches.
3. Y indexing with looping. Set 1 index and the software will
automatically calculate the indexing across the rest of the way of
your part.
4. Automatic blade height on setup and during cutting for blade
wear.
5. Manual inspect mode
6. "Soft Stop" Will stop at the end of the cut, raise the blade
and allow inspection of the cuts. Resume will start the cut again at the
stop point.
7. Variable speed on all axis with touch and slide on the Flat
Panel Screen. Decreases setup and inspect times by allowing infinite speed
control with just moving your finger farther away from the touch button
arrow.
Sample of Flat Panel InterfaceÓ
Re-engineered with pride and quality in the USA.
All Patents and Copyrights Apply DTT, Inc., 1997 |
